Olympus Perlcorder S950 - Page 6

I
I
lgl
How
to Use CUE
Mark
Signal
l. In REC
modg
press
the INDEX button
@
to record
CUE mark
(signal
to indicate
and
locate
the begin-
ning
of a recorded
portion).
2. For
CUE mark detection,
please
refer to
[3]
Cue/Review Function in
this instruction.
*
As
the CUE mark button is
depressed, the LED
indicator
@
blinks.
*When
in the VCVA
recording
waiting
modg
press-
ing the INDEX
button automatically records
the date
and
time on the taps
*
Utilization of the
CUE
mark
is
possible
only at the
tape speed
of
2.4
cm/s.
I
I
I10l
Playback
l. Set the TAPE SPEED
selector to the speed at
which
the tape was recorded
(Fig.
l0)
2. Set the mode
switch
@
to the
NORMAL
position.
(Frg.
6)
3. Press
the
PLAY
button
@.
4. Adjust the volume with VOLUME
control
knob
@.
(Fie.
7)
5. During
playback,
turning the PAUSE switch
@
to
PAUSE
position
sets the unit temporarily in stop
mode.
Returning
the PAUSE switch to
OFF
position
re-
sumes PLAY mode.
(Fig.
8)
6.
To
stop the tape,
press
the STOP button
@.
tDuring
playback,
'RECORDED
TIME",
'PLAY",
tape counter
and
the recorded
time are
displayed
on
the
IXD
panel.
Until the
recorded
time
is detected
(within
one
minute), date and
time are
not displayed
on the
LCD
panel.
When date and
time are
detected,
the recorded
date and
time are
displayed.
(Display
of
recorded
date and time
is effective
for
recording at
2.4 cm/s speed
only.
Täpe recorded
at
the 1.2 cmls
speed or tape
recorded
at other than
the
5950
cannot
display date
and time)
!
I [11]
Fast
Play
l.
Set
the mode switch
@
to the
F. PLAY
position.
(Frg.9)
2. Press the
PLAY button
@.
The tape
is
played
back
approximately
25q0
faster than the
normal speed.
+In
the
Fast Play
modg date
and time cannot
be
dis-
played
on the
I-CD
panel
I
1.
[12]
Fast Forward/Rewind
Function
During STOP
modg slide
the REWFF
switch
@
to
FF
position
to advance
the tape at
high
speed
(Fig.
ll). To stop tape
running,
return the
REWFF
switch to
the center
or
press
the
STOP button
@.
2. During STOP
mode, slide
the REWFF
switch
to
REW
position
to rewind
the tape
(Fig.
l2).
To stop
tape
running,
return the
REWFF switch
to the
center
or
press
the
STOP button.