EN 13
EN
Using the fiber cable adapter
The fiber cable adapter is required when connecting the separately
available UFL-1 underwater flash to the Case using an underwater optical
fiber cable (optional: PTCB-E02).
How to install
1 Attach the optical fiber cable adapter to the diffuser shown in the figure
below.
2 Put the underwater optical fiber cable plug all the way into the optical
fiber cable (optional: PTCB-E02) insertion slot.
Remove the underwater optical fiber cable when you do not use it while
taking picture.
PT-052_EN.book Page 13 Thursday, December 22, 2011 6:23 PM
To Next Page
Loading...
