Olympus Stylus 840 - Connecting the camera to a computer

D Note
Use a computer with a pre-installed operating system. Operations are not guaranteed on home-
built computers or computers with an updated operating system.
Operations are not guaranteed when using an added USB or IEEE 1394 (FireWire) port.
To install the software, you must log on as a user with administrators' privileges.
When using Macintosh, be sure to remove the media (drag & drop onto the trash icon) before
performing the following operations. Failure to do so could result in unstable computer operation
and the need to reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera's battery/card compartment cover
For how to install the OLYMPUS Master software, refer to the
installation guide included in the CD-ROM.
Connecting the camera to a computer
L...
Q)
.....
C/)
C'O
~
(f)
:::>
a..
~
>-
--l
o
01
C
C/)
:::>
46 EN
1 Make sure the camera is turned off.
• The monitor is off.
• The lens is retracted.
2 Connect the multi-connector on the camera to
the USB port on the computer using the
provided USB cable.
• Refer to your computer's instruction manual to locate the
position of the USB port.
• The camera turns on automatically.
• The monitor turns on and the selection screen for the USB
connection is displayed.
3 Select [PC], and press IOK/FUNCI.
Monitor
Multi-connector
Connector cover
SET·lQB)