Olympus Stylus 840 - When you get an error message on the camera

When you get an error message on the camera
Monitor indication
Possible cause
Corrective action
[J
There is a problem with the
This card cannot be used. Insert a new
card.
card.
CARD ERROR
[J
Writing to the card is
The recorded image has been protected
prohibited.
(read-only) on a computer. Download the
WRITE PROTECT
image to a computer and cancel the read-
only setting.
ill
The internal memory has no
Insert a card or erase unwanted data.
available memory and
Before erasing, backup the data of
MEMORY FULL
cannot store any new data.
important pictures using the card, or
download such pictures to a computer.
[J
The card has no available
Replace the card or erase unwanted data.
memory and cannot store Before erasing, download important
CARD FULL
any new data.
pictures to a computer.
,----"
There are no pictures in the The internal memory or the card contains
I I
internal memory or on the
no pictures.
I
I
"----,,
card.
Record pictures.
~
NO PICTURE
Q.)
+-'
+-'
Q.)
There is a problem with the Use image processing software to view the
.0
OJ
ro
selected picture and it
picture on a computer. If that cannot be
~
cannot be played back on done, the image file is damaged.
Q.)
PICTURE ERROR
E
this camera.
ro
Pictures taken by other
Use image processing software to edit the
(.)
OJ
~
cameras take in 1ITtl)], or pictures.
::J
0 THE IMAGE
previously edited or
>-
CANNOT BE
corrected pictures cannot be
3:
EDITED
edited or fixed.
0
c
The battery/card
Close the battery/card compartment cover.
::s:.
Q
0
compartment cover is open.
+-'
0>
CARD-COVER
c
OPEN
:.::;
+-'
Q.)
The battery is empty.
Charge the battery.
<.9
c:::J
BATTERY EMPTY
The card was not read. Or, • Select [CLEAN CARD], and press IOK/FUNcl.
the card is not formatted.
Remove the card and wipe the contact
area with a soft dry cloth.
• Select [FORMAT] ~ [YES] and press
IOK/FUNcl. All data on the card is erased.
There is an error in the
Select [MEMORY FORMAT] ~ [YES] and
internal memory.
press IOK/FUNcl. All data in the internal memory
is erased.
SET.~
~
The camera is not
Disconnect the camera and connect it
connected to the computer
again correctly.
NO CONNECTION or printer correctly.
I ~ I
There is no paper in the Load some paper in the printer.
printer.
58 EN
NO PAPER