Olympus Stylus Tough 8010 - Preparing the Camera; Inserting the battery; Battery charge and camera setup

11 EN
Preparing the Camera
3
STYLUS TOUGH-8010/
 TOUGH-8010
STYLUS TOUGH-6020/
 TOUGH-6020
STYLUS TOUGH-3000/
 TOUGH-3000
1
2
3
1
2
Insert the battery by putting in the  marked
side  rst, with the B marks toward the
battery lock knob.
Damage to the battery exterior (scratches,
etc.) may produce heat or an explosion.
Insert the battery while sliding the battery
lock knob in the direction of the arrow.
Slide the battery lock knob in the direction
of the arrow to unlock, and then remove the
battery.
When removing the battery or card, be sure
to turn off the camera before opening or
closing the battery/card/connector cover.
When using the camera, be sure to close
the battery/card/connector cover.
Battery charge and camera
setup
Connect the camera to the computer to charge
the battery and setup the camera.
System requirements
Windows XP (SP2 or later)/
Windows Vista/Windows 7
When using another system other than the
above or no computer, see “Charging the
battery with the included USB-AC adapter”
(p. 13).
Inserting the battery
1
STYLUS TOUGH-8010/
 TOUGH-8010
STYLUS TOUGH-6020/
 TOUGH-6020
STYLUS TOUGH-3000/
 TOUGH-3000
3
2
1
Battery/card/
connector cover lock
Battery/card/
connector cover
LOCK knob
2
1
Battery/card/
connector cover lock
Battery/card/
connector cover
2
STYLUS TOUGH-8010/ TOUGH-8010
Battery lock knob
STYLUS TOUGH-6020/ TOUGH-6020
STYLUS TOUGH-3000/ TOUGH-3000
Battery lock knob
STYLUS TOUGH-6020/
 TOUGH-6020
STYLUS TOUGH-3000/
 TOUGH-3000