If a problem arises
170
6
Appendix
The flash does not fire
n
The flash is set to [$].
n
Select a flash mode other than
[$].
P. 2 3
o
The subject was excessively
illuminated.
o
If you want the flash to fire on a
brightly illuminated subject, set
the flash to [#].
P. 2 3
The picture cannot be played back
n
The power is off.
n
Turn the camera ON. *1
o
The camera is in the shooting
mode.
o
Turn the mode dial to set at q or
press the QUICK VIEW button.
*1
p
No pictures have been taken.
p
Record pictures before playing
back.
*1
q
The picture information (file
name, etc.) was changed on a
computer.
q
To avoid camera malfunction,
do not change the information
on the card with a computer.
–
The date recorded in the picture data is wrong
n
The date/time is not set.
n
Set the date/time. The date
and time are not set at the time
of purchase.
P. 8 6
o
The camera has been left with
the battery removed.
o
Set the date and time again. P.86
p
The camera detected a prob-
lem in the power supply from
the battery/AC adapter during
operation.
p
The camera may stop working
if the power fails during opera-
tion. When normal operation is
restored, all the camera set-
tings may be reset. Set the
date and time again.
P. 8 6
q
A card charged with static
electricity was inserted.
q
Set the date and time again. P.86
The settings are reset to the factory default settings
when the camera is turned off
n
The camera was turned off
without saving the settings.
n
Set [ALL RESET] to [OFF]. P.88
The monitor is hard to see
n
The brightness is not adjusted
properly.
n
Adjust the monitor brightness. P.109
o
The monitor is exposed to
direct sunlight.
o
Block the sunlight with your
hand.
–
*1 See the separate Basic manual provided.
Possible cause Corrective action
Ref.
page
To Next Page
Loading...
