If a problem arises
172
6
Appendix
The picture is too dark
n
The flash was blocked by your
finger.
n
Hold the camera correctly. *1
o
The subject was out of the
working range of the flash.
o
Shoot within the flash working
range.
P. 2 4
p
The flash was set to [$].
p
Select a flash mode other than
[$].
P. 2 3
q
The picture was taken against
the light.
q
Set the flash to [#], or use the
spot metering mode.
P.23,
35
r
You took a picture of a bright
subject such as a snow-cov-
ered landscape.
r
You can take a beautiful picture
in this situation by selecting the
shooting mode [R](BEACH &
SNOW).
P. 1 4
The colors of pictures taken indoors look unnatural
n
Indoor lighting can affect the
picture’s colors.
n
Adjust the white balance to suit
the lighting.
P. 3 0
o
There was no white in the sub-
ject.
o
Include something white in the
picture, or shoot using the [#].
P. 2 3
p
The white balance setting is
wrong.
p
Adjust the white balance
according to the light source.
P. 3 0
The printer fails to connect
n
[PC] was selected on the moni-
tor after connecting to the
printer with the USB cable.
n
Remove the USB cable, and
start again from step 1.
P. 1 2 3
o
The printer does not support
PictBridge.
o
Refer to the printer’s instruc-
tion manual or contact the
printer manufactuer.
–
The camera is not recognized by the computer
n
The USB driver has not been
installed.
n
It is necessary to install the
USB driver for Windows 98/
98SE. Install the driver.
P.140,
157
*1 See the separate Basic manual provided.
Possible cause Corrective action
Ref.
page
To Next Page
Loading...
