1
IMPOR T ANT
This manual pertains only to the operation of the LED illuminator stand. Please also read the
instruction manuals for the SZ2 series or applicable microscope to understand the comprehensive
operating instructions of the microscope system.
SAFETY PRECAUTIONS
1. After the equipment has been used in an observation of a specimen that is accompanied with a potential of infection,
clean the parts coming in contact with the specimen to prevent infection.
· Moving this product is accompanied with the risk of dropping the specimen. Be sure to remove the specimen before
moving this product.
· In case the specimen is damaged by erroneous operation, promptly take the infection prevention measures.
· The product becomes unstable if its height is increased by an accessory mounted on it. In this case, take anti-toppling
measures to prevent the specimen from being dropped when the product topples down.
2. When moving the microscope, hold the bottom of the base with one hand and the pillar with
the other hand, and carry the microscope without tilting it.
· Before carrying, remove the stage glass so that it will not drop during carrying.
Also remove other modules from the microscope as they may increase the weight and
increases danger.
3. LED (Light Emitting Diode) device is included in this product.
· Do not stare at the LED illumination (particularly the reflected illumination) light directly, as this may damage your eye.
· When a mirror or similar element is engaged in the illumination light path, take special care against the reflected light
that may enter your eye.
· Use of controls or adjustments performance of procedures other than those specified herein may result in hazardous
radiation exposure.
4. Always use the power cord provided by Olympus. If no power cord is provided, please select the proper power cord by
referring to the section “PROPER SELECTION OF THE POWER SUPPLY CORD” at the end of this instruction manual. If the
proper power cord is not used, product safety performance cannot be warranted.
5. Always ensure that the grounding terminals are properly connected. If the equipment is not grounded, Olympus can no
longer warrant the electrical safety performance of the equipment.
6. If water or a liquid is spilt on the top of the LED illuminator stand, treat it quickly and properly as described in
“
2 Maintenance and Storage” below.
Symbol Explanation
Indicates that the main switch is ON.
Indicates that the main switch is OFF.
Before use, carefully read the instruction manual. Improper use could result in personal injury to
the user and/or damage to the equipment.
Safety Symbols
The following symbols are found on the equipment. Study the meaning of the symbols and always use the equipment in
the safest possible manner.
Indicates the transmitted light illumination.
Indicates the reflected light illumination.
To Next Page
Loading...