Saving battery power between shots Displaying the current altitude/
[POWER SAVE] water depth (atmospheric/hydraulic
......... ............pressure) [MANOMETER]
......._,_ MANOMSIF-R ..........................................................................
¢_ Th.... dings mayh ....... gin of .....
Cancels[POWERSAVE]. dependingon meteorological conditions,
When the camera is not being Use the readings only for your reference.
usedforapprox. 10seconds,the
ON monitorautomaticallyturns offto
save batterypower,
To resume standby mode
Press any button or turn the mode dial.
Using the LED illuminator as an
auxiliary light [LED ILLUMINATOR]
Disables the LED illuminator.
ON Enables the LED illuminator.
_ "Using the LED illuminator" (p. 24)
OFF Cancels the manometer display.
Displays the current altitude/
water depth (atmospheric/
ON hydraulic pressure) in the
shooting standby mode screen.
-10 m to 5,000 m)
CALIBRATE Proceed to the setting screen.
See below.
_ When set to [ON], a warning message
appears in the monitor as a water depth
close to 10 m (32.8 ft) is reached.
To adjust the altitude/water depth
display
% Use _'@_ to select the current altitude/
water depth, and press the _ button to
set.
Selecting the display units for the
manometer [m/ft]
..... sBzuR_m/_t.....................
ft
This displays in meters.
This displays in feet.
EN
To Next Page
Loading...
