Olympus XZ-10 - Image Aspect Ratio and Bracketing

44 EN
Frequently-used options
3
Setting the image aspect (Image Aspect)
You can change the aspect ratio (horizontal-to-vertical ratio) when taking pictures.
Depending on your preference, you can set the aspect ratio to [4:3] (standard), [16:9],
[3:2] or [1:1].
# Cautions
• JPEG images are cropped to the selected aspect ratio; RAW images, however, are not
cropped but are instead saved with information on the selected aspect ratio.
• When RAW images are played back, the selected aspect ratio is shown by a frame.
Disable the button function (dLock)
Select [On] to disable the I, G and sub dial in shooting mode.
Varying settings over a series of photographs (Bracketing)
Bracketing enables you to take a series of shots at different exposure settings. Select
the exposure compensation from 0.3 EV, 0.7 EV, or 1.0 EV. Bracketing is available
in P, A, S, and M modes. The camera continues to take shots in the following
order while the shutter button is pressed all the way down: no modification, negative,
positive. Number of shots: 3
1
Select [Bracketing] in J shooting menu 2.
2
1
c
Back
Shooting Menu 2
Set
w 0.0
Image Stabilizer
Bracketing
# Sync
Off
Off
# Sync 1
Remote Flash
Super-Res Zoom
Off
Pic Orientation On
2
Select the exposure compensation using FG.
• Bracketing is available after pressing the jY button
(G) in the monitor and selecting [BKT].
2
1
c
0.0
Off
Off
# Sync 1
Off
3f 0.3EV
3f 0.7EV
3f 1.0EV
Back
Shooting Menu 2
Set
w
Image Stabilizer
Bracketing
# Sync
Remote Flash
Super-Res Zoom
Pic Orientation On
• The camera modifies exposure by varying aperture and shutter speed (mode P), shutter
speed (modes A and M), or aperture (mode S).
• The camera brackets the value currently selected for exposure compensation.
• When an art filter (j –
Y
) selected in [Picture Mode] (P. 32, 42), the filter effect is not
applied.