STEREO PAIRING (Requires two Mantra speakers) STEREO OPERATION (Requires two Mantra speakers)
ON THE FIRST MANTRA:
Pair the first Mantra as instructed earlier in this manual.
Make sure first Mantra is turned on. Touch and hold
the Play/Pause until Stereo Pairing tone is activated.
Red and Green LED will flash alternately. First Mantra
is now ready for stereo pairing.
ON THE SECOND MANTRA
Turn second Mantra on. When Green LED lights begin
flashing slowly, the second Mantra is ready to continue.
Touch and hold the Play/Pause until Stereo Pairing
tone activated. Red and Green LED will flash alternately.
System is now waiting for Stereo pairing (10-20 seconds).
PAIR CONFIRMATION
Pair tone will activate on both Mantras after Stereo
pairing was successful.
AFTER PAIRING
:
After Stereo pairing, the first Mantra will become the
Master and switch into Left channel automatically,
the second Mantra will act as the Slave and play
Right channel accordingly.
MASTER STEREO
:
Only the Master is capable of communicating with
your Bluetooth device, such as Play/Pause, Volume
control and selecting song. The Master will revert back
to Mono if the Slave is powered off or unpaired.
TOUCH SENSOR
The touch sensors are disabled on the Right channel
Mantra while in Slave mode.
LEFT/
MASTER
RIGHT/
SLAVE
To Next Page
Loading...
Need help?
General