Omcan Imbera VR10 User Manual (English)

Questions and Answers:

D
Diana BarnesJul 26, 2025
Why is my Omcan Refrigerator temperature too high?
- T
  Todd ClarkJul 26, 2025
  If the Omcan Refrigerator isn't cooling adequately, several factors could be at play. Ensure you wait at least 14 hours after connecting the cooler for it to reach optimal temperature. A dirty condenser coil can also hinder cooling, so clean any dust, lint, or waste from the coil. Similarly, a blocked or frozen evaporator coil can cause issues; turn the cooler off to defrost it. Avoid keeping the doors open for extended periods, and allow hot products sufficient time to cool before loading them. Lastly, ensure proper air flow by arranging products to avoid obstructions and not exceeding the maximum fill height.
P
Paul BrownJul 30, 2025
What to do if Omcan Imbera VR10 cannot be turned on?
- B
  Brittany BoyerJul 31, 2025
  If your Omcan Refrigerator won't turn on, first ensure that the electricity service is working. Then, check that the refrigerator is correctly plugged into the outlet. If it was just connected, wait at least 5 minutes for the compressor to start. Finally, check the fuse or circuit breaker and replace or reset if necessary.
E
Eddie FloresAug 4, 2025
Why does my Omcan Imbera VR10 Refrigerator run continuously?
- N
  norman45Aug 5, 2025
  If your Omcan Refrigerator runs continuously, start by cleaning the condenser coil to remove any accumulated dust, lint, or waste. If the evaporator coil is blocked by frost, turn the cooler off to defrost it. Ensure that the doors are not left open for extended periods and that they seal properly; adjust the door or replace the seals if needed. Also, avoid placing excessively hot items inside the refrigerator, allowing them to cool first.
A
Amanda BushAug 9, 2025
What to do if Omcan Imbera VR10 compressor won't start?
- J
  James DonaldsonAug 10, 2025
  If the compressor in your Omcan Refrigerator isn't starting, is making buzzing noises, or stops due to the thermal protector, first ensure that the voltage supply is stable and sufficient. Clean any dust, lint, or waste from the condenser coil. Also, check for and remove any obstructions to airflow around the refrigerator. If the vent motor is burnt or the fan blade is damaged, it is required to call Customer Service Center.
A
anna88Aug 15, 2025
How to fix Omcan Refrigerator that vibrates and makes noises?
- H
  harrissharonAug 15, 2025
  If your Omcan Refrigerator is vibrating or making unusual noises, ensure it's placed on a firm, flat surface. Remove any items like carpeting or cardboard from underneath it. Adjust the leveling supports until all four points are stable. Tighten any loose parts, and separate any components that may be vibrating against each other.
M
meganschultzAug 20, 2025
Why did the lights turn off in my Omcan Imbera VR10?
- M
  Michael MurphyAug 20, 2025
  The lights on your Omcan Refrigerator might be off because it is set to energy saving mode. This mode is typically deactivated when the door is opened.

Omcan Imbera VR10 Specifications

General

Brand	Omcan
Model	Imbera VR10
Category	Refrigerator
Door Type	Glass Door
Number of Shelves	4
Defrost Type	Automatic
Refrigerant	R290
Voltage	115V
Hertz	60 Hz
Phase	1
Type	Vertical Refrigerator
Exterior Material	Steel