OMEGA AIR RDL 35 - User Manual

Questions and Answers

T
Tiffany GonzalezAug 17, 2025
What to do if there is a high compressor outlet temperature in OMEGA AIR RDL 35?
- B
  bradykimberlyAug 17, 2025
  A high compressor outlet temperature in your OMEGA AIR Dryer can be caused by several factors. Overload heat or high input air temperature may be the cause, so establish normal operating conditions. Ensure adequate ventilation. A dirty condenser or a malfunctioning fan can also contribute. If the hot gas bypass valve isn't properly set up or there's a coolant leak, consult a refrigeration engineer. Reset the thermal switch or replace it if defective.
D
dawnhawkinsAug 20, 2025
Why the compressor does not work on OMEGA AIR Dryer?
- M
  Megan HubbardAug 20, 2025
  If your OMEGA AIR Dryer's compressor isn't working, it could be due to activated internal thermal protection. Wait 30 minutes and try again. Check the electrical installation. If installed, replace the internal thermal protection, start-up relay, start-up capacitor, or working capacitor. The HPS or LPS pressure sensor might have been activated. The TS thermal safety switch may have been activated, refer to the relevant section of these instructions. If the compressor still isn't working, consider replacing it.
V
Vanessa KennedyAug 23, 2025
Why is the dewpoint too high in my OMEGA AIR RDL 35 Dryer?
- M
  Mckenzie MarshAug 23, 2025
  A high dewpoint in your OMEGA AIR Dryer can be caused by several factors. It could be due to the dryer not starting or the compressor not working. Check if the dew point sensor is fully inserted into the sleeve. Ensure adequate ventilation and that the inlet air isn't too hot, or the inlet pressure isn't too low. Reduce the flow of inlet air if it's higher than the dryer's flow. Clean the condenser if it's dirty, and ensure the condenser fan is working. Also, check that condensate has been drained from the dryer. For issues with the hot gas bypass valve or leakage in the cooling circuit, contact a refrigeration specialist.
P
Penny GonzalezAug 26, 2025
What to do if OMEGA AIR RDL 35 Dryer does not start?
- J
  Jeff BellAug 26, 2025
  If the OMEGA AIR Dryer does not start, ensure that the system is connected to a power source and check the electrical installation (internal and external).
B
Bradley MillerAug 28, 2025
Why there's water in the pipeline of my OMEGA AIR RDL 35?
- F
  freycassandraAug 28, 2025
  If there's water in the pipeline connected to your OMEGA AIR Dryer, ensure that unprepared air isn't flowing through the bypass conduit by closing it. Also, check if the dryer is discharging condensate and whether the dew point is too high.
G
Gregory CraigAug 30, 2025
What to do if the condensate was not drained from the OMEGA AIR RDL 35 Dryer?
- A
  andersonpatrickAug 31, 2025
  If the condensate was not drained from the OMEGA AIR Dryer, check the electrical installation. A low dew point might cause the condensate to freeze and block the air flow. Ensure the compressed air pressure is adequate for condensate removal and that the electronic condensate drain is functioning correctly.
A
Andrea MendezSep 2, 2025
Why is the dewpoint too low in my OMEGA AIR RDL 35?
- H
  haileyortegaSep 2, 2025
  If the dewpoint is too low in your OMEGA AIR Dryer, it may be due to the fan always being on because the PV pressure switch is defective, replace it. It could also be that the ambient temperature is too low, so establish nominal operating conditions. For issues with the hot gas bypass valve, contact a refrigeration engineer.
D
David GlennSep 5, 2025
Why OMEGA AIR RDL 35 Dryer continuously drains the condensate?
- C
  Casey ShafferSep 5, 2025
  If the OMEGA AIR Dryer continuously drains condensate, it may be because the electronic condensate separator is dirty.
J
Jason TrevinoSep 8, 2025
Why is there excessive pressure drop in the OMEGA AIR Dryer?
- B
  Brian VargasSep 8, 2025
  An excessive pressure drop in the OMEGA AIR Dryer can occur if condensate hasn't been drained, if the dew point is too low causing frozen condensate to block airflow, or if there are issues with the pipe connections, so check the dampening of the pipe connections.
S
Samantha HowardSep 12, 2025
What to do if the condenser fan does not work in OMEGA AIR Dryer?
- S
  Suzanne MccarthySep 12, 2025
  If the condenser fan in your air-cooled OMEGA AIR unit isn't working, check the electrical installation. The PV pressure switch may be defective and need replacement. If there's a leakage in the cooling circuit, contact a refrigeration engineer. If the fan still doesn't work after these checks, replace it.