WOS - Installation and operating manual
6
Installation
· Unpack the device
· It is recommended to place the device near the wall. Test valve is located on front
side of the device.
· Make sure that you have easy access to the front side of the device.
· Take both bags (carbon and polypropylene) out and remove protection foil from both
filter bags. Then put the cartridge back in the device.
· Make sure that white filter element is inserted in chamber 1 and carbon filter
element is inserted in chamber 2.
· Fill the device with clean water!
· Connect device to the system.
· Outlet must be connected to the sewage system.
Warning
It is strongly recommended to fill the device with clean water at least 24h (we recommend
to fill water into cartridge 1 day before installation/service) before you start to drain
condensate into the separator. If you start to drain condensate into an empty device, filter
element can get saturated instantly or efficiency may be decreased.
To Next Page
Loading...
Need help?
General
