What to do if my Omega Lifting Systems jack will not lift the load?
If your Omega Lifting Systems jack isn't lifting, it could be due to a few reasons. First, ensure the release valve is tightly closed. It also might be an overload condition, so remedy that if it exists. Finally, check that the air pressure is adequate.
Why is the lift performance of my Omega Lifting Systems poor?
Poor lift performance in your Omega Lifting Systems could stem from a low fluid level; ensure it's at the proper level. It could also be caused by air trapped in the system; follow the bleeding/venting trapped air procedure.
What to do if Omega Lifting Systems jack will not lower after unloading?
If your Omega Lifting Systems jack won't lower after unloading, several factors could be at play. Check if the reservoir is overfilled and drain fluid to the proper level, if needed. Also, linkages might be binding, so cleaning and lubricating moving parts is advised. Finally, ensure the fluid level is proper.
Why is my Omega Lifting Systems jack lifting but not maintaining pressure?
If your Omega Lifting Systems jack lifts but doesn't maintain pressure, it could be that the release valve isn't tightly closed; make sure that it is. Another potential cause is a hydraulic unit malfunction. If this is the case, discontinue use and contact Omega technical service.
General| Brand | Omega |
|---|---|
| Model | 21032 |
| Category | Lifting Systems |
| Language | English |
To Next Page
