42 43
English
Adjusting the length (fig. 7):
free the longer section of the
strap by removing the two studs
from the holes (fig. 3). Adjust the
strap as required and replace the
two studs in the holes (fig. 4). Try
the watch for size and readjust if
necessary.
fig. 5
fig. 6
b) Foldover clasps with pushers
Opening (fig. 5): to open the clasp, press the two pushers
on either side of the
OMEGA
buckle and pull upwards.
Closing (fig. 6): put the watch on your wrist and close the clasp
by pushing on it with your thumb until you hear a click.
fig. 7
Foldover clasps
Specifi c sections/general information4
Using the rotating bezel (fig. 8)
: keep the pusher A pressed down
to turn the bezel.
Using the crown (fig. 8): the crown B must be unscrewed before it
can be used, when the crown protection C will slide without turning.
After use, push the crown to position 1, then press and screw the crown
down again (to ensure the water resistance of the case).
Note: the crown is located at 9 o’clock, but its functions are identical.
Using the fine length adjuster (fig. 9)
Using the diving extension (fig.10)
Note: to fold the diving extension away, it is important to proceed
according to fig. 10.2 (with the diving extension perpendicular to the
cover of the clasp).
Ploprof bezel and crown
Specifi c sections/general information4
fig. 8
fig. 9
fig. 10
fig. 10.1 fig. 10.2 fig. 10.3
OMEGA_V12-I.indb Abs1:42-Abs1:43OMEGA_V12-I.indb Abs1:42-Abs1:43 28/12/09 18:30:4928/12/09 18:30:49
To Next Page
Loading...
