16
EN
STORAGE
1. Drain the carburetor by loosening the screw.
Drain the gasoline into a suitable container
2. Change the engine oil (see page 13).
3. Remove the spark plug, and pour about a tablespoon of clean
engine oil into the cylinder. Crank the engine several revolutions
to distribute the oil, then reinstall the spark plug.
4. Slowly pull the starter grip until resistance is felt. At this point,
the piston is coming up on its compression stroke and both the
intake and exhaust valves are closed.
Storing the engine in this position will help to protect it from in-
ternal corrosion.
G a s o l i n e i s e x t r emely fl a m m a b l e a n d i s explos i v e u n d e r c e r t ain
conditions. Perform task in a well-ventilated area with the engine stopped.
Do not smoke or allow flames or sparks in the area during this procedure.
WARNING
To check:
1. Turn off the engine switch and loosen the drain screw.
2. Turn the fuel valve to ON. Fuel should flow from the drain when the
fuel valve is turned ON.
9. TROUBLESHOOTING
Is there fuel in the tank? Rell the fuel tank
Is there enough oil in the engine? Add the recommended oil
Is the spark plug in good condition?
Readjust gap and dry the spark plug.
Replace it if necessary.
Readjust gap and dry the spark plug.
Replace it if necessary.
Is the spark plug in good condition
If the engine still does not start, take the
generator to an authorized to manual.
YES
NO
NO
NO
NO
YES
YES
YES
When the engine will not start:
To Next Page
Loading...
Need help?
General
