PROGRAMMING
All programming operations are only possible with the
door closed
.
To select a new program, the dishwasher must be in the "
Program
start
" state described above. Turn the
PROGRAM SELECTOR (5)
to
the program of your choice (see "
P
ROGRAMS
T
ABLE
").
START PROGRAM
Press the
START/PAUSE
button
(3)
for a few seconds, until
the
START/PAUSE
light
(4)
starts to flash. A beep confirms
the operation.
PROGRAM SEQUENCE
For the entire duration of the program,
ON/OFF (2)
indicator
light remains permanently on, whereas the
START/PAUSE
(4)
indicator light flashes.
END PROGRAM
To indicate the end of the program, a short beep sounds
and the
ON/OFF (2)
and
START/PAUSE (4)
lights
illuminate simultaneously.
Before a new washing cycle can be selected the dishwasher
must be in "
Program start
" state: press the
START/PAUSE
button
(3)
until the configuration of indicator lights
(2)
and
(4)
is as follows.
INTERRUPTION OF A PROGRAM
Press the
START/PAUSE
button
(3)
for a few seconds, until
the configuration of the
ON/OFF (2)
and
START/PAUSE (4)
lights is as follows.
You may now restart ("
S
TART PROGRAM
") or change the program which
was interrupted.
1935
42 8
1935
42 8
6
7
15
User instructions
To Next Page
Loading...
