19
IF ThE AUGER STOPS WORKING
2
1
Press [ON] button to operate properly.
When using the [ON] or [Rev} button, make
sure the auger stops completely after
stopping or releasing the button
Note:
Even after following the directions above,
if the juicer still doesn’t work, please
unplug the power cord, disassemble the
chamber set and clean it. Then try again.
Press [Rev] button for 3 to 5 seconds,
then release. When the [Rev] button is
released, the auger will stop rotating.
Repeat this 2 to 3 times.
The [Rev] button pushes the ingredients
upward releasing the food clog.
To Next Page
Loading...
