2
Installation
Selection of installation equipment
Drill holes on the table surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the table surface is at least 30mm. Please select
heat-resistant table material to avoid larger deformation caused by the heat
radiation from the hotplate.
As shown in Figure (1)
Air intake
Figure (2)
mini 5 cm
mini 760mm
mini 2 cm
Under any circumstances, make sure the ceramic cooker hob is well
ventilated and the air inlet and outlet are not blocked.Ensure the ceramic
cooker hob is in good work state. As shown in Figure (2)
Air exit
mini 5 mm
56 cm
49 cm
+0.4
+0.1
+0.4
+0.1
To Next Page
Loading...
