Omega ODW717WB - Cleaning the Filter; Cleaning the Door; Protect against Freezing; Cleaning the Spray Arms

The cont rol panel can be clea ned by using a lightly dampen ed c lot h.
Af ter cl eaning, make sure to dry i t tho roug hly.
For the e xterior, us e a good app lianc e po li s h wax.
Never u se shar p obj ects, sco ur ing pads o rh arsh clea ners on a ny part of the dis hw asher.
Protect Again st Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and d is connec t the water inlet pipe from the water valve.
3.Drain the wat er from the inle t p ip e an d wat er va lve. (Use a p an to gathe r the water)
4.Reconnect the wate r inl et pi pe t o the water valve.
5.Remove t he f ilter at the bottom o f the tub and use a sponge to soak up water in t he sum p.
pl ease t ake fros t pr ot ectio n m easures on t he dishwasher in winter. Every fter washing cycles,
pl ease op erate as foll ows
time a
：
Cleaning the Filter
Cleaning The Door
To c l ean t h e c o a rse fil ter a nd t he fine fi l t e r, us e a cl ean i n g brush . R e as semble the filter part s as shown i n t h e fi gures
on t he previous p ag e an d r ein ser t t he e nt ir e assemb ly i n t he di shwash er, p os i t i onin g i t i n its seat an d pr es sin g d own ward s.
When cle aning the filters, don't knock on them. Otherwise, the filters could be
contorted and theperformance of the dishwashercould be decreased.
To cle an th e e dge around the d oor, you shoul d use only a sof t wa rm, dam p clot h.
To avoi d pene trat ion o f wa ter in to t he d oor l ock and electr ical com ponen ts, d o not
use a spray cle aner of any ki nd.
Never u se a spr ay cl eaner t ocle an t he door panel as it may damage the door loc k
and electrical components.
Ab rasive ag ent sor som e paper towels shou ld not be used because o f t he r isk o f
scra t c hing o r l eav ing spot s on the s tai n les s stee l surfa ce.
Cleaning the Spray Arms
I f your dishwa sher cannot wor k beca use of the ice,
pl ease con tact professiona l ser vice pe rson s.
It is ne cess ar y t o cl e an t h e s p ray arms regular l y for hard
water chemicalswill clog the spray armjetsandbearings.
- Ins pect the filt ers fo r blo cking a fter e very ti me th e dis hwa sher has be en used .
- By uns crew ing the c oar se fi lter, you can remove t he filter syst em . Re move a ny foo d re mna nts and
clean thefilters under runningwater.
Remarks:
The entire filter assembly should be cleaned once a week.
To removethelower spray arm,pull out the spray arm upward.
To r e move th e up per s p ra y arm , ho ld t he n ut, r ot ate th e arm
clockwise to removeit.
Wash the arms in soap y and warm water and u se a soft br ush t o
clean the j ets . R eplace them af ter ri nsing the m th oroughly.