Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the !)User Manual
Electric indicator on control panel (if pro vided).
Check the rinse aid level
Load the baskets
Select a programme
Turn o n the water tap and press the . T he machine w ill start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading th e dishwasher to av oid handling
the dishes and utensils while they are still hot and more sus ce ptible to break.
They will also dry b etter.Unload t he appliance, st arting from the lower b asket.
Changing the programm e
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. Soften r emnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loadin g instructions.
Close the door,press the Programme Button until the selected progr amme lights up.
( See the section entitled Operation instruction )āā
When the wor k ing cycle has finished, the buzzer of the
dishwasher will soun d 8 tim es, then stop.
Turn off the a ppliance using the Power Bu tton.
If the appliance is switched
off during a w ash cycle.
Open t he door car eful l y.
Hot st eam may escape
when thedooris opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate th e dishwasher
according to the original Power-on state.
Switch on the appliance Press the Power button to switch on the appliance, Open the door.
For detailed operating method read the co rresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the deterg ent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.
P ress the Start/Pause butto n, press the program button for more than three seco nds,the
machine will be in standby state, then you can change the program to the desired cycl e setting
1.Press the Start/Paus e Button to stop the washing.
2.Open the door a little .
3.After the spray ar ms stop work in g, you can ope n the door
completely.
4.Add forgotten dishes.
5.Close the door.
6.Press the Start/Pau se Button, th e dishwasher will run
after 10 seconds.
To Next Page
Loading...
