8
Installation Instructions
WARNING: Before placing the appliance, check that the local distribution conditions (gas type and
pressure) conform to the product settings.
Ensure the appliance is at the correct height to the benchtop. If required, adjust the legs in order the make
level with the benchtop.
Ensure the appliance is on a level surface and in a well ventilated environment.
For Natural Gas Connection – 1.0 kPa (test point Pressure)
WARNING: Natural gas connection should be done by an authorized person.
For natural gas connection, the appliance should be connected to the gas supply via an isolation valve
making sure the valve is easily accessible after the appliance is installed.
Connect the appliance to the gas piping tap in the shortest possible route and in a way that ensures no gas
leakage will occur.
Install the supplied natural gas regulator to the gas inlet pipe of the appliance. If required, ensure the gas
supply piping avoids routing across the back of the appliance.
This may be done by connection on either side of the appliance via the secondary gas inlet connection. Be
sure to cap off the unused gas connection and check for gas leaks before commissioning the appliance.
WARNING: While performing a gas leakage check, never use any kind of lighter, match, cigarette, or
similar burning substance.
Apply soup solution to the connection points. If there is any kind of leakage then it will cause bubbling.
For LPG Connection – 2.75kPa
For LPG connection, install a dedicated test point adaptor between the gas inlet connection and the gas
supply pipe. An isolation valve should be used upstream to disconnect the gas supply during installation or
servicing.
To Next Page
Loading...
