Omega OFI101X - Washing and Drying Result Issues; Error Codes and Warnings

Troubleshooting
Problem
Possible Causes
What To Do
Un-satisfactory
washing result
The dishes are
not clean
The dishes were not loaded
correctly.
See notes in
"Loading the Dishwasher Baskets ".
The program was
not powerful enough.
Select a more intensive program.
See" Wash Cycle Table ".
Not enough detergent was
dispensed.
Use more detergent, or change your detergent.
Items are blocking
the path of spray arms.
Rearrange the items so that the sprayer can
rotate freely.
The filter combination is not
clean or is not correctly fitted.
This may cause the spray arm
jets get blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the
Spray Arms".
Cloudiness
on glassware
Combination of soft water and
too much detergent.
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware
and to get them clean.
Black or gray
marks on
dishes
Aluminum utensils have
rubbed against dishes.
Use a mild abrasive cleaner to eliminate those
marks.
Detergent left
in dispenser
cups
Dishes block
detergent cups opens.
Re-loading the dishes properly.
Un-satisfactory
drying result
The dishes are
not drying
Improper loading
Load the dishwasher as suggested in the
directions.
Too little rinse-aid
Increase the amount of rinse-aid/Refill the rinse-
aid dispenser.
Dishes are removed too soon
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the
steam can escape. Begin unloading the
dishwasher only once the dishes are barely
warm by touching.
Wrong program selection
In short program the rinse temperature is lower.
Choose a program with a high rinse
temperature.
Using cutlery with a low-quality
coating
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Error Code
When some malfunctions occur, the appliance will display error codes to warn you:
WARNING
■ If overflow occurs, turn off the main water supply before calling a service.
■ If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
Codes
Meanings
Possible Causes
Longer inlet time.
Faucets is not opened, or water intake is
restricted,or water pressure is too low.
E3
E4
Some element of dishwasher leaks .
Overflow.
E1E1E1
Not reaching required temperature.
Malfunction of heating element .
27