INSTALLATION OF THE APPLIANCE
WARNING:
The electrical connection of this hob should be carried out by a qualified electrician, according to
the instructions in this guide and in compliance with the current regulations. In the event of any
damage that occurs as a result of improper connection or installation, the warranty will not be valid.
This appliance must be earthed.
Installation safety
·
Any overhanging surface should be at least 65cm above the hob.
·
Extractor fans must be fitted in accordance with the manufacturer's instructions.
·
The wall in contact with the rear of the hob must be made of flameproof material.
·
The power cable length should not exceed 2 metres.
Fitting the hob into a work surface
·
The hob can be inserted into any worktop provided it is heat resistant up to at least 90ºC.
·
Create an opening with the dimensions shown in the picture below and on next page.
·
Induction hob may be built in the 25 to 40 mm thick worktops.
·
Warning: This product needs to be adequately ventilated to operate properly and ensure long life.
Please see diagram below.
78cm induction hob
To Next Page
Loading...
