8
4-4-1 AUTO Mode-Continuous
Operation
From the SCAN mode (Trigger is pulled), you can
lock the trigger electronically and measure
temperature continuously (AUTO mode) by pressing
the LOCK key. The AUTO icon will appear on the
display. Pressing the LOCK key again will disable
the AUTO mode. AUTO icon will disappear from the
display. If the trigger is pulled, the unit stays in the
SCAN mode. If the trigger is released, the unit will go
to HOLD mode and will shut itself off after about 6
seconds.
The following table shows an overall functional flow
chart of the thermometer:
Mode Press Mode Key Press Up Key Press Down Key
SCAN SCAN AUTO ---- ----
AUTO AUTO DATA Record ---- ----
DATA DATA RECORD DATA + Memory Location - Memory Location
RECORD RECALL
(Press M key to record)
(Flashing) (Flashing)
DATA DATA RECALL Max Temp + Memory Location - Memory Location
RECALL
Display Data Memory Display Data Memory
Max Temp Max Temp Min Temp + Memory Location - Memory Location
(Flashing) (Flashing)
Min Temp Min Temp Avg Temp + Memory Location - Memory Location
(Flashing) (Flashing)
Avg Temp Avg Temp ∆T + Memory Location - Memory Location
(Flashing) (Flashing)
∆T ∆T TC + Memory Location - Memory Location
(Flashing) (Flashing)
TC TC Emissivity +Memory Location –Memory Location
(OSXL689) (Flashing) (Flashing)
Emissivity Emissivity High Alarm + Emissivity – Emissivity
HAL High Alarm Low Alarm + Alarm Set Point – Alarm Set Point
LAL Low Alarm SCAN/HOLD + Alarm Set Point – Alarm Set Point
4-4 Advanced Functions
To Next Page
Loading...
