Need help?Do you have a question about the Omega 24 and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Accuracy | ±0.5°C |
| Resolution | 0.1°C |
| Probe Type | Stainless steel |
| Measurement Range | -50 to 300°C (-58 to 572°F) |
Essential warnings and guidelines for safe operation of the instrument.
Identifies and explains unit self-diagnostic fault conditions and error codes.
Describes the procedure for powering on the unit and initial display test.
Details how to use the unit as a thermometer for thermocouple measurements.
Explains thermometer operation for RTD, Thermistor, and Ohms measurements.
Covers saving and retrieving up to 10 meter readings with their parameters.
Outlines using the unit as a calibrator for thermocouple outputs.
Details calibrator operation for RTD, Thermistor, and Ohms outputs.
Explains how to store and recall up to 10 calibrator output settings.
Describes sequentially recalling stored data in calibrator mode.
Details automatic and manual ramping features for specific models.
Step-by-step guide for calibrating the unit's functions.
Specific procedures for calibrating resistance measurement and simulation functions.
Procedures to verify the calibration accuracy of thermocouple and resistance functions.
To Next Page
