Omega OTEC IEWH Series - Remote Controller Display; Remote Display Elements; Remote Controller Instructions

-12-
〖Remote Controll
er Display〗
Turbo Dis
play
Operating Mode
Selection Display
Signal Emission Symbol
It appears when control
signal is emitted.
Setting temp Display
It appears when turbo fu
nction
is set in COOLING or HEAT
mode, and will flash.
AUT
O
HEAT
COOL
DRY
SWEEP
Wind Speed Selection
Display
Displayed the setting
temperatur
e.
Timer Display
Display hour when setting
timer to turn on or turn
off the air conditioner
On/Off Timer Display
The ON/OFF symbol will display
when setting the timer.
Auto
High speed
Medium speed
Low speed
Vertical
Sw
ing Display
Displayed in according with
ver
tic
al blad
es position and
swing or not.
HEALTH Display
It appears when health
function is set.
Sleep Mode Display
Displayed when Pressing
“Sleep” button, the unit will
run in sleep mode.
Horizontal Sw
ing
Displa
y
Displayed when Pressing
“H-SWEEP button.
Lock Display
Displayed when Pressing
“LOCK” button.
Instruction for remote controller

The remote controller uses two AAA batteries under normal condition, the batteries last
for about 6 months. Please use two new batteries of similar type (pay attention to the poles in
install
ing). After replacing the batteries, please use a point object (such as pen tip) to
press
“Reset” button.
 When using remote controller, please point the signal emitter towards indoor unit receiv
er;
There should be no obstacle between remote controller and indoor unit.

Pressing two buttons simultaneously will result wrong operation.
 Do not use wireless equipment (such as mobile phone) near indoor unit. If interference o
ccurs
beca
use of this, please switch off the unit, pull out power plug, then plug again and switch on
after a whil
e.

There is no direct sunlight to the indoor receiver, or it can not receive the signal from
the remote
control
ler.
 Don’ t cast the remote controlle
r.
 Don’ t put the remote controller under the sunlight or near the oven.
 Don’ t sprinkle water or juice on the remote controller, use soft cloth for cleaning if it occurs.
 The batteries must be removed from the appliance before it is scrapped and that they are
disp
osed of safety.