USER MANUAL ROUTER 4 in 1 - ΩMEGA O31 - WIRELESS N ROUTER 150M.
Thank you for purchasing a wireless router brand ΩMEGA. We have made every effort to ensure that the
device meets your expectations. If you have any questions relating to its operation, please visit
www.omega-technology.eu, where in the support section you will find additional materials about this
device.
The configuration procedure consists of hardware installation and software configuration.
Hardware Installation
According to the description on the packaging unit, connect the cables in the following order:
a) plug RJ45 network cable internet signal to the WAN port of the router
b) if the router is connected by wire to a computer: plug the network cable to the port RJ45 LAN / WAN
port of the computer and the router's LAN
c) Connect the power cord to the supplied AC adapter and power supply connected to the mains (230V).
d) if the router is connected wirelessly to a computer - no need to connect additional cables.
Starting the router, takes about a minute, after which the LEDs should indicate operation and you can
proceed to the software configuration.
Software Configuration
1. Configuration of the example of a computer operating system Microsoft Windows 7.
1.1 Click
：
“
【
Start
】
—
【
Control Panel
】
—
【
Network and Internet
】
—
【
Network and Sharing Center
】
—
【
Change adapter settings
】
—
【
Local Area Connection
】
”
，
select the connected network card
，
Then right
click“Local Area Connection”
，
select
【
Properties
】
1.2 Select
【
Internet Protocol Version 4(TCP/IPv4)
】，
click
【
Properties
】
To Next Page
Need help?
General