Omega Pro 80600 - Charging and Operational Guidance; Charging the Jumpstarter; Power Indicator; Jump Start Procedure

3
CHARGING THE JUMPSTARTER
* At Home
1. Insert the USB wall adapter provided into an outlet and insert the USB plug into the wall
adapter.InsertthemicroUSBplugintotheJumpStarterchargingport.
2. TheLED'sashindividuallyduringcharging.Theunitisfullychargedonceall4powerLED's
are on.
3. Chargetimetofullcapacityisbasedonsize,seeSpecicationstablefordetails.
* In A Vehicle
1. Ensurethatthevehicleelectricalsystemis12V.DoNotattempttochargetheunitfroma24V
vehicle system.
2. InserttheUSBplugintoanappropriate12VchargingsocketwithUSBoutput(notincluded).
InsertthemicroUSBplugintotheJumpStarterchargingport.
3. TheLED'sashindividuallyduringcharging.Theunitcellisfullychargedonceall4power
LED's are on.
* From A Desktop Computer or Laptop
1. InserttheUSBplugintotheUSBportofthecomputerwiththecomputerturnedon.Insert
microUSBplugintotheJumpStarterchargingport.
NOTICE:Tomaintaintheinternalbatteryoftheequipment,chargetheunitassoonaspossible
after using to start a vehicle or to charge batteries in other electrical equipment
.
NOTICE: Iftheproductisnotusedforalongperiodoftime,fullychargetheunitthenstoreit.
Chargeonceevery3months.
OPERATIONAL GUIDANCE
* Power Indicator
1. Pressthepowerbuttontoshowpowerindicatorlight,seebelow.
Power Indicator Lightless LED Flash 1 LED 2 LED 3 LED 4 LED
BatteryCapacity 0% 10% 25% 50% 75% 100%
2. Toensureoptimumconditionofunitbattery,chargefullyassoonaspossibleafteruse.
3. Ifthepowerindicatorlightremainsoffafterswitchingtothe"on"position,theunitcellisfully
discharged. Please charge the unit as soon as possible to avoid damage.
Jump Start 12V for Gasoline Engines under 5 Liters (310 in³)
1. Withaminimumof3powerindicatorLEDalight,thisunitcansuccessfullyjumpstarta12V
petrolvehiclewithenginesupto5L.Chargetheunitimmediatelyafteruse.
2. Beforeattemptingtojumpstartavehicle,itisadvisabletoturnoffallvehicleelectricalappli-
ances,suchasradio,airconditioning,internalandexternallightsetc.
3. InsertthelargerJumpStartercableblockintothe12VJumpStartersocket.
4. ConnecttheredclampoftheJumpStartercabletotheREDpositive(+)batterycableand
theblackclamptotheBLACKnegative(-)batterycable.Thegreenlightonthecabletop-box
willlightwhentheclampsarecorrectlyttedtothevehiclebatterycables.Theredlightonthe
cabletop-boxwilllightiftheclampsareincorrectlyttedtothevehiclebatterycables.
IMPORTANT:Iftheredlightisonthecabletop-boxthencheckandre-ttheclampstothe
vehicle battery before attempting to start the engine.
5. Ifthegreenlightisonthecabletop-boxthenyoucanturnthevehicleignitiononandstartthe
engine.
6. Afterthevehicleengineisstarted,thecabletop-boxashesandcutsoffthepowercircuitto
invoke inverse charge protection.
7. OncetheJumpStarterisconnectedtothevehiclebattery,thecabletop-boxbeginstocount.
Ifthetimeexceeds45secondsandthecabletop-boxentersdormancymodeshowinga
slowashredlight.Justremovetheredclampfromavehiclebatteryandconnectitback.
The green light illuminates again and then users can start the vehicle engine.
IMPORTANT: Operational guidance is continued on the next page. Please read ALL the
instructions before using the unit to avoid damage to the unit or property and injury.