Omega Pro 80600 - Advanced Operations and Specifications; Operational Guidance Continued; USB Output Functionality; LED Torch Operation

4
OPERATIONAL GUIDANCE CONTINUED
8. Remove the blue plug of Jump Starter cable block from the 12 V Jump Starter socket of the
host and then remove the clamps of Jump Starter from the car battery.
!
WARNING: DONOTleavethehostunitconnectedtoacarbatteryformorethan15seconds
ortheunitcancatchre.DISCONNNECTtheunitwithinlessthan15secondsofusewhether
or not the car starts OR FIRE AND/OR INJURY COULD RESULT!
NOTICE
If the red and green lights on the black box of the Smart Jump Starter cable are not working during
jumpstartingthevehicle,pleaseresetthejumpstarterasfollows:
1. Removetheredclampfromthepositive(+)terminalofthecarbattery.
2. Connecttheredclampbackonthepositive(+)terminal.Nowthegreenlightisonagainand
the product is ready for use.
NOTICE:
1. Beforeattemptingtostarttheengineofavehicle,checkthatthebluecableplugisfullyinserted
into the unit's 12 V Jump Starter socket. Failure to have this properly connected to the unit can
cause a bad connection which may result in failure to start or damage to the unit/plug.
2. Iftheenginefailstostart,(1)checkthattheJumpStarterpowerLEDshaveatleast3barslit,
(2) checkthatthevehicleisinfullworkingorder,(3)checkthatthevehicle'sbatteryhasenough
charge,(4)checkthattheclampsarefullyconnectedtothevehicle'sbattery.
3. Iftheenvironmentambienttemperatureislowerthan14°F/-10°Catthelocationofthecarbat-
tery,thevehicleenginemaynotstartonthersttry. The vehicle's battery will need to reach a
working temperature in order to be started smoothly
.
OUTPUT: USB DC5V/2A
1. UseaUSBconnectioncabletocharge5Vmobilephonesandotherelectronicproductsfrom
theUSB5V2AoutputportoftheJumpStarter.
2. Connect the product to the Jump Starter and then press the power switch. The power LEDs
arealight;meantheJumpStarterischargingtheproduct.
LED TORCH
Switch button operating cycle is as follows:
1. Press twice the power switch to start the LED torch.
2. Press once more to enter S.O.S. mode.
3. Pressagaintoturnoffthelight.
Specication 80600,80600R
Output
USB-DC5V/2A
Jumpstartport(EC5)-DC12V
Input
DC5V/1A
Charge Time
6hourson5V/1A
Capacity
6,000mAh
Weight
8.47oz.
Dimensions
5.43x2.95x
.63in
Starting Current
350A
Peak Current
700 A
Suitable Engine
12V/GasolineEngine<5.0L
Operating Temp.
Storage Temp.
-4°F~140°F(-20°C~60°C)
-4°F~176°F(-20°C~80°C)
SPECIFICATIONS
LED Torch
12 V Jumpstart
Socket
USB5V/2A
Output
MicroUSB
Input Charge Port
Power
Switch
Power
Indicator