11-8
7. Press the ESC key to finish the adjustment. The screen returns to the
Basic=P_Adj screen.
Select Zero or Full.
Change the value to adjust the pen
position.
The dot printing position moves.
ESC/?
Basic=P_Adj
P_Adj=Hysteresis
P_Adj
Setting complete
Hysteresis=-2
Applying the Changes and Returning to Operation Mode
Press the key or SHIFT + key to select End and then press the key. Press
the key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the
key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key
to return to the Basic= screen.
11.6 Adjusting the Dot Printing Position (Dot Model)
To Next Page
Loading...