Omnia 3

69
preset in order to save it as a unique name.
ands the Omnia to save the current settings as preset BOOGY.
ifiable parameters available for the current preset in a table format.
Lists all possible values for the parameter at the given index number.
ets a new value for the selected parameter.
justable
n a table format with their current setting value in brackets. Example: typing sysparas <enter>
displ f lowing able:
[A tereo]
8) Input LPF [15kHz] 17) Output Master [+10.0dB]
eft rim [+0
33) Daypart State [ENABLED]
) Ctrl Port Baud
49) Backlight [60] 50) Editing Mode [EXPERT]
) Sepa tion [S
61) Ave. Power ['no-disp']
Setting New Syspara Values
ysparavalues <sy or any parameter.)
Example: sysparavalues 54 <enter> Displays a table listing the possible Pilot Level values.
Note: Factory presets are permanent and cannot be written over. You must use the ‘saveas’ command when
saving changes made to a factory
saveas Saves the preset under a different name.
Example: saveas BOOGY <enter> Comm
Non-System Parameters (paras)
paras Lists the mod
Example: paras <enter> displays the parameters for the current preset:
paravalues <index #>
para <para index #> <paravalue> S
Omnia-3fm Turbo System Parameters
A 'syspara' is an Omnia-3 System parameter. The System Parameters are assigned to controls which govern
overall operation, such as Input and Output Gains, Pre-emphasis/De-emphasis, etc. These parameters would
NOT be saved with individual presets, but instead are saved using the Save To Card option in the System menu.
To obtain a list of all System parameters, you use the command 'sysparas', which lists all of the ad
parameters i
ays the ol t
1) Input Source ES/EBU] 2) Mono Mode [S
3) Input Phase [INVERT] 4) Input Master [+6.0dB]
5) Left Trim [+0.0dB] 6) Right Trim [+0.0dB]
18) L T .0dB] 19) Right Trim [+0.0dB]
26) Headphones [-10.0dB]
34 [19200] 48) Contrast [90]
51) Composite 1 [3.60 V] 52) Composite 2 [3.60 V]
53) SCA Level [-20.0dB] 54) Pilot Level [8.0%]
55 ra TEREO] 56) Phase Adjust [0 deg]
57) Analog Phase [1] 58) Preemphasis [75uS]
59) Deemphasis [75uS] 60) BS412 [OFF]
To find the new value you wish to use for a particular Syspara:
s spara index #> Lists all the possible values f