Omnia 3

95
Card does not have valid OS!!!
the rear-panel memory card do not match what the operating system expects or there is
card.
d in memory
e non-volatile RAM on the motherboard do not match what is on the rear-panel
hen the Omnia is booted up for the first time with a new rear-panel software card
ch as
s to
NVRAM failure
em was unable to write to the non-volatile RAM on the motherboard.
therboard may have failed.
initialize RTC
m could not initialize the Real Time Clock on the motherboard.
ip on the motherboard may have failed.
a Customer Support for assistance.
oltage
Failed DSP #x Bootstrap, contact CE.
t able to initialize one of the Omnia’s DSP cards or one of the two DSP
ssistance.
ERROR: read failed write address, DSP #x
escription: The operating system was unable to communicate with the DSP's host port.
rd DSP controller / router chain components.
al path routing through the DSP chain.
ause: Possible failure of motherboard DSP controller / router chain components.
Electrical and mechanical safety note!
Whe is top cover removed, you are exposed to potentially lethal voltages
and
Befo
to th
Description: The contents of
no bootable image on the
Cause: The card may be damaged, its data corrupted or it may contain the wrong software version.
Resolution: Try a new rear-panel memory card of the correct software version for your unit.
No previous system foun
Description: The contents of th
memory card.
Cause: This error may show up w
or when the Omnia booted up for the first time after the non-volatile memory (NVRAM) has been cleared, su
after replacement of the battery.
Resolution: Simply click OK in the error dialog box and the error should clear. If not and the Omnia continue
show this error at each boot-up, contact Telos / Omnia Customer Support for assistance.
Description: The operating syst
Cause: The NVRAM on the mo
Resolution: Contact Telos / Omnia Customer Support for assistance.
Failed to
Description: The operating syste
Cause: The Real Time Clock ch
Resolution: Contact Telos / Omni
Dead battery, data lost.
Description: The Lithium battery used for system configuration backup is being reported as dead or battery v
is too low for reliable operation.
Resolution: Contact Telos / Omnia Customer Support for assistance.
Timed out loading DSP.
Description: The operating system was no
IC's on the card.
Cause: One of the DSP cards or DSP chips may have failed.
Resolution: Contact Telos / Omnia Customer Support for a
Host command bit not clear
D
Cause: Possible failure of DSP or motherboa
Resolution: Contact Telos / Omnia Customer Support for assistance.
Failed Routing, contact CE.
Description: The operating system was unable to establish the correct sign
C
Resolution: Contact Telos / Omnia Customer Support for assistance.
n the Omnia is operated with its chass
high speed rotating fan blades.
re attempting to make voltage measurements, be forewarned that the power supply heat sinks are connected
e AC power line. Avoid these areas whenever the AC power cable is attached to the Omnia.
Never attempt
ake measurements when the power supply's safety cover is removed.
to m