Omnifilter OMNI OM40KCS

Questions and Answers

T
Tony NobleAug 18, 2025
What to do if my Omnifilter OMNI OM40KCS control will not recharge automatically?
- D
  David RamosAug 18, 2025
  To resolve the issue of the Omnifilter Water Dispenser not recharging automatically, ensure the AC adapter or motor is properly connected to provide power. If the connections are secure and the problem persists, the motor may be defective and require replacement. Also, the meter might be clogged with debris; you should remove and clean the meter. Note that the unit will recharge every 7 days anyway.
J
James DuranAug 21, 2025
Why is there hard water leakage after recharge in my Omnifilter OMNI OM40KCS?
- J
  Jessica DiazAug 21, 2025
  If your Omnifilter Water Dispenser is leaking hard water after a recharge, it could be due to several reasons. First, try repeating the recharge, ensuring that the correct salt dosage was set. If the issue continues, check for a leaking external bypass valve and replace it if necessary. Also, inspect the O-ring around the riser pipe for damage and replace it if needed.
K
Kevin MooreAug 23, 2025
How to set the correct recharge time on my Omnifilter Water Dispenser?
- J
  Jonathan WhiteAug 23, 2025
  If your Omnifilter Water Dispenser control recharges at the wrong time of day, the Time of Day setting is likely incorrect. To fix this, set the correct Time of Day on your control.
M
Morgan CantrellAug 26, 2025
What to do if my Omnifilter OMNI OM40KCS Water Dispenser valve will not draw brine?
- R
  Richard SchneiderAug 26, 2025
  If your Omnifilter Water Dispenser valve won't draw brine, it could be due to a restricted drain line, which you should remove. Alternatively, the injector might be plugged; clean the injector and screen. Debris may also be preventing the valve discs from closing, so remove any foreign matter from the valve discs.
B
brianmurphyAug 27, 2025
Why is my Omnifilter OMNI OM40KCS Water Dispenser salt tank overflowing?
- W
  Wayne BaileyAug 27, 2025
  If your Omnifilter Water Dispenser is experiencing a salt tank overflow, ensure all salt line connections are tight. Additionally, check the drain line for any restrictions caused by debris and clean the drain control if necessary.
L
Laurie MillerAug 30, 2025
Why is there no conditioned water after recharge in my Omnifilter OMNI OM40KCS Water Dispenser?
- M
  Melissa CunninghamAug 30, 2025
  If you're getting no conditioned water from your Omnifilter Water Dispenser after a recharge, the salt tank might be empty; add salt to the salt tank. Another possibility is that the injector is plugged; in this case, clean the injector and screen.
J
James BushSep 1, 2025
What to do if there is flowing or dripping water at the drain or salt line after recharge on my Omnifilter Water Dispenser?
- C
  Crystal OliverSep 1, 2025
  If you notice flowing or dripping water at the drain or salt line of your Omnifilter Water Dispenser after recharge, debris may be preventing the #4 valve disc from closing; remove the debris. If the issue persists, the #4 valve disc may be worn and require replacement.
T
tara35Sep 3, 2025
Why doesn't the flow indicator display service flow on my Omnifilter Water Dispenser control?
- M
  Michael AcostaSep 3, 2025
  If the flow indicator on your Omnifilter Water Dispenser control does not display service flow, first check if the bypass valve is in the bypass position and remove it from bypass. Also, ensure the meter cable is fully inserted into the valve. Finally, the meter might be clogged with debris, so remove and clean the meter.
M
Matthew SmithSep 6, 2025
Why does my Omnifilter OMNI OM40KCS Water Dispenser backwash or rinse at an excessively low or high rate?
- J
  Jonathan EvansSep 6, 2025
  If your Omnifilter Water Dispenser backwashes or rinses at an excessively low or high rate, it could be due to the absence of a drain line flow control; install a drain line flow control. Another cause might be a restricted drain line, which you should remove.
C
Christopher RodriguezSep 8, 2025
Why does my Omnifilter Water Dispenser run out of conditioned water between recharges?
- H
  Heather KirkSep 8, 2025
  If your Omnifilter Water Dispenser runs out of conditioned water between recharges, the control might be improperly programmed. Verify the salt dosage to correct this.