EasyManuals Logo

Omnitronic E-Series User Manual

Omnitronic E-Series
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
00043864.DOC, Version 1.1
30/32
10. PROBLEM CHART
PROBLEM CAUSE REMEDY
No power. The power cord is not connected. Check the power cord and any
extension cables.
No sound. The power cord of the respective
device is not connected properly or
n
ot connected at all.
The connection socket or the plug is
dirty.
Check the power cord and if the
plugs are tightly connected with the
s
ockets.
Clean the socket and/or the plug.
Fan does not work, LEDs
d
o not light up.
The power cord is not connected.
Please check if the power is
a
vailable
Protect LED lights up
permanently.
Inputs receive DC voltage.
Amplifier is overheated due to
impurities.
Impedance of speakers too low.
Short-circuit in speaker connection or
in speakers.
Technical default of amplifier.
Switch amplifier off and have the
device checked by a service-
technician.
Clean the fan grille.
Connect other speakers.
Check speakers.
Switch amplifier off and have the
device checked by a service
technician.
11. CLEANING AND MAINTENANCE
Disconnectfrommainsbeforestartingmaintenanceoperation!
DANGERTOLIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
11.1 Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omnitronic E-Series and is the answer not in the manual?

Omnitronic E-Series Specifications

General IconGeneral
BrandOmnitronic
ModelE-Series
CategoryAmplifier
LanguageEnglish

Related product manuals