6
PM-1655-E-01-01/2018
11. When treatment is completed, turn the power off and unplug the compressor
from the power outlet. The wound-up power cord can be stored in the
compartment at the back of the device.
12. Clean and disinfect all (disassembled) parts.
Review the Instruction Manual for the full details on the application of this product.
How to use the nasal shower
Preparation:
1. To add the solution to the nasal shower tank, lift the upper part out of the tank
and remove it.
2. Pour the solution in the tank (max 15 ml).
3. Close the nasal shower by placing back the upper part.
4. Connect one end of the air hose to the nasal shower and the other end to the
compressor.
5. Turn on the compressor to begin the treatment.
Operation:
1. Operation is to be done by pressing/releasing the button before/during exhaling.
During treatment, hold the other nostril, to which the nasal shower is not applied,
closed with one finger. Keep a handkerchief ready to dry the nostrils if mucous
overflows from the trap in the upper part of the nasal shower.
2. When the mist starts disappearing from the nasal shower the treatment is done.
3. After use, dispose of any solution from both upper part and tank, disassemble
the Nasal Shower and clean the parts.
Review the Instruction Manual for the full details on the application of this product.
To Next Page
Loading...
Need help?
General
