OMRON ELECTRONICS LTD ● Technical Support: 0870 752 0871 or visit www.myOMRON.com
41
JX-MX2 INVERTER REFRESH FUNCTION BLOCK
PNSPO
Controls and monitors up to 31 JX
and MX2 inverters (in any
combination) via a 2-wire RS485
network.
No additional programming
required, other than defining
which ‘nodes’ are present and
which type of inverter (JX or
MX2) is used at each ‘node’.
JX-MX2 INVERTER REFRESH FUNCTION BLOCK
PNSPO
#CCCC means that we’re using
this Function Block with a CP-
series PLC and &2 means that the
CP1W-CIF11 RS422/485 module
is located in Port 2
To Next Page
Loading...
