Motion and Drives
Integrated programming and configuration for a comprehensive
range of position and motion controllers.
Integrated Support Software for Special Units
The Support Software for Temperature Controllers
(CX-Thermo) can be started from the CX-Integrator’s Serial
Communications Window. Of course, settings such as the
PLC and Unit information are passed to the CX-Thermo,
so you can start designing HMI screens immediately after
the CX-Thermo starts.
Position/Motion Control Unit Support Software Startup with Unit Information inherited from the I/O Table
• The Support Software for a Position Control Unit
or Motion Control Unit (CX-Position, CX-Motion, or
CX-Motion-NCF) can be started from a CX-Programmer
PLC I/O table.
• Parameter settings for complex motion operations can
be set much more efficiently and incorrect settings
can be avoided because the setting dialog boxes are
organized by parameter function and the Support
Software has a thorough help function.
• CJ1W-NCF71
Motion Control Unit
Support Software
(CX-Motion-NCF).
• Position Control
Unit Support
Software
(CX-Position).
The CX-Designer can be started from the CX-Integrator’s
NT Link Window. Of course, settings such as the PLC and Unit
information are passed to the CX-Designer, so you can start
developing screens immediately after CX-Designer starts.
• Motion Control Unit Support Software (CX-Motion).
Controller Link
MECHATROLINK-IIDeviceNet
To Next Page
Loading...
