www.cx-one.com
Basic style programming for complex motion tasks using dedicated high-speed motion bus
CX-Drive – modular software to program, configure and maintain inverters and servos
One software is used to configure and maintain the
complete range of OYMC inverters and servos,
regardless of the connection – serial direct, through
a PLC or on a high-speed motion network.
For more complex motion control Basic style programming
units can be programmed and configured using CX-One.
For more information and to get your free 30-day trial version of Cx-One then please go to
MECHATROLINK-II
Serial, modem or Ethernet
To Next Page
Loading...
