Regulation and switching
Programming and configuration for Temperature Controllers
through to complex multi-loop controllers with tools
to automatically create HMI pages.
The Support Software for Temperature Controllers
(CX-Thermo) can be started from the CX-Integrator’s
Serial Communications Window. Of course, settings
such as the PLC and Unit information are passed to the
CX-Thermo, so you can start designing HMI screens
immediately after the CX-Thermo starts.
• The CX-Thermo Software can be started from a device in the CX-Integrator’s
serial communications (CompoWay/F) network.
• Parameters can be created, edited, and transferred at the computer.
The time required to make settings can be reduced when setting the same
parameters in multiple devices.
• Unused parameters can be freely masked (not displayed) to avoid
incorrect operations.
Position/Motion Control Unit Support Software Startup with Unit Information inherited from the I/O Table
Parameters that need to be set are arranged in the window
to be more visible.
The functions and allowed setting ranges of the parameters
are displayed in the Setting Window, so it isn’t necessary
to refer to the manuals.
Controller Link
CompoWay/FDeviceNet
To Next Page
Loading...
