Omron FH-L550

FH-L550 Series
18
Components and Functions
* Use the attachment power terminal connector (male) of FH-XCN-L series.
For details, refer to 5-3 Sensor Controller Installation on Vision System FH/FZ5 series Hardware Setup Manual(Z366).
LED name Description
[1] PWR LED Lit while power is ON.
[2] ERROR LED Lit when an error has occurred.
[3] RUN LED Lit while the layout turned on output setting is displayed.
[4] ACCESS LED Blinks while the internal nonvolatile memory is accessed.
[5] SD PWR LED Lit while power is supplied to the SD memory card and the card is usable.
[6] SD BUSY LED Lit when access to the SD memory card.
[7] Ethernet NET RUN LED Lit while Ethernet communications are usable.
[8] Ethernet LINK/ACT LED Blinks when connected with an Ethernet device, and blinks while performing communications.
Connector name Description
A
SD memory card installation
connector
Install the SD memory card. Do not plug or unplug the SD memory card during measurement operation.
Otherwise measurement time may be affected or data may be destroyed.
B USB 2.0 connector
Connects to USB 2.0. Do not insert or remove during loading or writing of measurement or data.
The measurement time can be longer or data can be damaged.
C USB 3.0 connector
Connects to USB 3.0. Do not insert or remove during loading or writing of measurement or data.
The measurement time can be longer or data can be damaged.
USB 3.0 has a high ability to supply the bus power.
Use the Sensor Controller by combining USB 3.0, faster transport can be realized.
D Ethernet connector
Connect an Ethernet device.
Ethernet port, EtherNet/IP port, and PROFINET port are sharing use.
E RS-232C connector Connect an external device such as a programmable controller.
F DVI-I connector Connect a monitor.
G
Parallel connector
(control lines, data lines)
Connect the controller to external devices such as a sync sensor.
H Camera connector Connect a camera.
I Power supply terminal connector
Connect a DC power supply. Wire the controller independently on other devices. Wire * the ground line.
Be sure to ground the FH Sensor Controller alone.
[1]
[3]
[5]
[2]
[4]
[6]
[7]
[8]
F
G
H
D
E
I
A
C
B
Lite Controllers
(4-camera type)