17
5 Turn the power switch to the off ( ) position.
The compressor turns off and nebulization stops.
6 Disconnect the air tube from the nebulizer kit.
Hold the air tube plug and gently pull down to disconnect the air tube plug
from the air tube connector on the bottom of the nebulizer kit.
7 Check the air tube. No condensation or moisture should remain in the air tube.
WARNING
Do not store the air tube with moisture or medication remaining in the air tube.
This could result in infection as a result of bacteria.
If any condensation or moisture remains in the air tube, remove the moisture
from the air tube. Follow the directions below:
1. Make sure the air tube is still connected to the air tube connector
on the upper side of the compressor.
2. Press the power switch on. The compressor will start and pump
air through the air tube to expel the moisture.
3. Press the power switch again to turn the compressor off.
8 Disconnect the air tube from the compressor. Hold the air tube plug and
gently pull the air tube plug off the air tube connector on the upper side of the
compressor.
9 Unplug the AC adapter from the
electrical outlet.
CAUTION
• Unplug the AC adapter from the electrical
outlet after using the device.
• Remove the AC adapter from the device
after use.
• Do not pull the power cord of AC adapter
strongly.
USING THE DEVICE
To Next Page
Loading...
Need help?
General
