2 Ultra-slim Signal Converter K3FP Series
Applications
External device
2-conductor
PT100
3-conductor
PT100
4-conductor
PT100
Width: Just 6.2 mm.
Data Logger
Alarm
indicator
Digital Panel Meter
Consider the following products for judging non-DC
signal inputs.
For AC current single-phase signal inputs: K8AB-AS
For AC voltage single-phase signal inputs:
K8AB-VS/K8AB-VW
For AC voltage three-phase signal inputs: K8AB-PW
For thermocouple and platinum resistance
thermometer sensor inputs: K8AB-TH
Select the number of conductors for the input platinum resistance
thermometer using the DIP switch on the side of the Unit.
Set any input range from −150°C to 850°C.
The input signal provides power for the Isolator, so power supply
capacity does not need to be considered when expanding Units:
No power line wiring is required.
This ultra-slim 6.2-mm Signal Converter can be installed in limited
space, such as where expansion is required, and help to reduce the
overall size of devices.
K3FP-RS-UI RTD Transducer
K3FP-VS-UI-UI
Dual Output 3-Way Signal Isolator
K3FP-VS-UI-2I
K3FP-SL-UI
Limit Value Switch
Install in Limited Space
Isolators That Do Not Require Power Supply
K3FP Series
One-channel Passive Loop-powered Isolator
K3FP-SN1-I-I
Two-channel Passive Loop-powered Isolator
K3FP-SN2-I-I
Reduces Spare Parts
Three- and four-conductor RTD Transducers
Isolated Duplicate Signal Output
Limit Value Switches
Input and output ranges are
set using a DIP switch on
the side of the Unit.
Output signal
0 to 10 V DC
2 to 10 V DC
0 to 5 V DC
1 to 5 V DC
0 to 20 mA DC
4 to 20 mA DC
Input signal
0 to 10 V DC
2 to 10 V DC
0 to 5 V DC
1 to 5 V DC
0 to 20 mA DC
4 to 20 mA DC
4 to 20 mA DC
4 to 20 mA DC
Input signal
0 to 20 mA DC,
4 to 20 mA DC,
0 to 10 V DC,
1 to 5 V DC
(switch using
DIP switch)
Field device
For details, refer to Measuring and Monitoring Relays K8AB Series/
61F-D21T (Cat. No.: N141).
Page 33Page 10
Page 23Page 6
Page 14
Page 14
Note:
3-Way Signal Isolator
To Next Page
Loading...
