4 Screen Creation
4-14
NB-series Programmable Terminals Startup Guide Manual(V109)
User should use this method to create total 8 screens for this project, the screen No. and names
are listed as below:
2
Double-click “Wait” Screen to open [Screen Property], select “Background Color” and set
“Background Color” to “lightCyan”.
z Bit Button Component
1
Bit Button component for switching to the maintenance screen
The Bit Button component is placed on the upper left corner of the screen. Pressing this hiding
button (Bit Button component) to switch to maintenance screen ([6 Check 1] screen).
Function: Pressing the button and turn ON W_bit0.02, the display of PT will be switched to [6.
check 1] by the ladder program of CP1E. The Function Key is set transparent and will not
function until being pressed for 3 seconds for the purpose of avoiding being pressed
accidentally.
Select [Bit Button component] from [Parts], drag it to the edit window after selecting it with a
single-click.
The property settings are:
Screen No Screen Name
10 Wait
11 Open
12 Close
13 Stop
14 Fully Open
15 Check1
16 Check2
17 Check3
Write Address W_bit0.02
Bit Button Types On
Graphics Use the vector graphic:
Dashed.vg (A vector graphic created by user,
which is a light cyan rectangle)
Control Setting
(Security Setting)
ON Delay 3s
To Next Page
Loading...
Need help?
General
