2. Preparation
10
2. Push the button to confirm.
Blue light will flash.
3. Press the O/I START button to save settings and turn the
monitor off.
Resetting to the Default Setting
The positioning indicator is set “on1”, the wrist for measurement is set “ ”, and the buzzer is set
“on1” as default.
To reset to the default setting, press and hold down the SET button while in the setting mode,
then press the O/I START button simultaneously for more than 2 seconds.
HEM-6052-E_B_M_main.book 10 ページ ２０１１年１０月１２日 水曜日 午後２時４７分
To Next Page
Loading...
