2. Preparation
EN
9
Setting the Wrist for Measurement
1.
Push the button to toggle between “ ” (Left) and “ ” (Right).
: Taking a reading on the left wrist.
: Taking a reading on the right wrist.
2.
Push the button to confirm your choice and move onto the next step.
Setting the Buzzer
1. Push the button to
choose which mode of the
buzzer you wish to have.
If the Positioning indicator is “on1” or “on2”:
on1: The buzzer sounds only when the monitor is in proper position.
on2: The buzzer sounds a series of two short blips if your wrist is too far away from the
measuring position, and sounds slowly when your wrist is in proper position.
oFF: The buzzer will not sound.
If the Positioning indicator is “oFF”:
on: The buzzer sounds when pressing any buttons.
oFF: The buzzer will not sound.
HEM-6052-E_B_M_main.book 9 ページ ２０１１年１０月１２日 水曜日 午後２時４７分
To Next Page
Loading...
Need help?
General
