Omron R88D-KN30F-ECT-L User Manual

10 - 7
10 Operation
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
10-2 Preparing for Operation
10
10-2-3 Checking the Displays
Check the status of the status indicators.
If the RUN indicator will not turn ON or the ERR indicator will not turn OFF, refer to 5-1-2 Status
Indicators on page 5-3 and check the status.
EtherCAT Status Indicators
A
*1. “ ” will flash when a Safety Input Error (Error No. 30.0) occurs. “ ” does not flash on the display.
Warning occurs Warning cleared
Main power supply turned
ON and EtherCAT
communications
established.
Main power supply interrupted and
EtherCAT communications not established.
Servo ON Servo OFF
[— —]
[— —] + Dot on right lights.
[00] + Dot on right lights.
Error occurs Error cleared
Warning code
(for 2 s)
Normal code
(for approx. 4 s)
Error Display
*1
Normal Display (LED Display Selection (3700 hex) set to 0)
The main error code flashes as a decimal
(example for an overload).
Warning Display
The hexadecimal warning code and the
normal display are displayed alternately
(example for an overload).

Omron R88D-KN30F-ECT-L Specifications

General

Brand	Omron
Model	R88D-KN30F-ECT-L
Category	Servo Drives
Language	English