Omron Sysmac NJ-series - Page 5

Relevant Manuals
The following table provides the relevant manuals for the NJ/NX-series CPU Units. Read all of the
manuals that are relevant to your system configuration and application before you use the NJ/NX-ser-
ies CPU Unit.
Most operations are performed from the Sysmac Studio Automation Software. Refer to the Sysmac
Studio Version 1 Operation Manual (Cat. No. W504) for information on the Sysmac Studio.
Manual
Basic information
Purpose of use
NX-series CPU Unit Hardware User’s Manual NX-series NX102 CPU Unit Hardware User’s Manual NX-series NX1P2 CPU Unit Hardware User’s Manual NJ-series CPU Unit Hardware User’s Manual NJ/NX-series CPU Unit Software User’s Manual NX-series NX1P2 CPU Unit Built-in I/O and Option Board User's Manual NJ/NX-series Instructions Reference Manual NJ/NX-series CPU Unit Motion Control User’s Manual NJ/NX-series Motion Control Instructions Reference Manual
NJ/NX-series CPU Unit Built-in EtherCAT Port User´s Manual NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual NJ/NX-series CPU Unit OPC UA User’s Manual NX-series CPU Unit FINS User’s Manual NJ/NX-series Database Connection CPU Units User's Manual NJ-series SECS/GEM CPU Units User's Manual NJ-series Robot Integrated CPU Unit User’s Manual NJ-series NJ Robotics CPU Unit User's Manual NJ/NY-series NC Integrated Controller User’s Manual NJ/NX-series Troubleshooting Manual
Introduction to NX701 CPU
Units
¡
Introduction to NX102 CPU
Units
¡
Introduction to NX1P2 CPU
Units
¡
Introduction to NJ-series Con-
trollers
¡
Setting devices and hardware
¡ ¡ ¡ ¡
Using motion control
¡
Using EtherCAT
¡
Using EtherNet/IP
¡
Using robot control for OM-
RON robots
¡
Relevant Manuals
3
NJ/NX-series Motion Control Instructions Reference Manual (W508)