208
Section 8 Browser Operation Window
RFID System
User's Manual
(Modbus TCP)
Section 8
Browser Interface
Browser Operation Window
Connect the Ethernet cable and start a Web browser on the computer.
Enter the IP address of the Reader/Writer in the address field of the Web browser to display the browser
operation window.
Enter http://192.168.1.200 if you are using the default IP address.
If a Web password is not set in the Reader/Writer, the Status View will be displayed first.
To display another view, click the specified menu button.
Only one browser can connect to the Reader/Writer at one time. If another browser B connects to the Reader/
Writer while browser A is displaying the Reader/Writer interface, browser A will be cut off and the Reader/
Writer will communicate with browser B.
There is case where WEB browser can not be used in a combination of the firmware version of Reader/Writer and the JRE
version.
Refer to the table above, please use the JRE version that was appropriate for your Reader/Writer.
The system requirements to use the Web browser are as follows:
• Internet Explorer 7 or higher running on Windows XP or Windows 7
• The combination of the firmware version of Reader/Writer and the JRE version
JRE version
Java 6 Java 7 Java 8
Ver1.01 Available Available Not available
Ver2.00 Available Available Not available
Ver3.00 Not available Available Available
See Note.
Ver3.01 Not available Available Available
Note. Java8 update74 (February 5, 2016) or later can not be connected.
Reader/Writers
firmware version
* Windows is a registered trademark of Microsoft Corporation in the USA and other countries.
Screen shots are used with permission from Microsoft.
* Java software can be downloaded from the following.
URL: http://www.java.com/en/
•Java and other trademarks that contain “Java” are the registered trademarks of Oracle Corporation or
its related companies.
http:// (IP_address)
Click this button to change to the Configuration View.
Select the language to display.
Click this button to reboot the Reader Writer.
Click a button to display the specified view.